seatbelt
01-14-2011, 10:45 PM
#3
Super Member
Join Date: May 2009
Location: Atlanta, GA
Posts: 818
Likes: 0
Received 3 Likes
on
2 Posts
'02 C230 Coupe (Me) '03 SLK320 6MT (Wife)
The receptacle part should bolt to the floor. Obvious once you get the seat out, just make sure you torque them back right if you replace them.
However, if you are talking about the black plastic that goes around the buckle part, I believe the only way to get that is to replace the entire belt/buckle assembly.
However, if you are talking about the black plastic that goes around the buckle part, I believe the only way to get that is to replace the entire belt/buckle assembly.
01-14-2011, 10:49 PM
#4
MBWorld Fanatic!
Join Date: Jun 2009
Location: Queens, Ny
Posts: 1,833
Likes: 0
Received 2 Likes
on
2 Posts
Nike Turbo Shox
The receptacle part should bolt to the floor. Obvious once you get the seat out, just make sure you torque them back right if you replace them.
However, if you are talking about the black plastic that goes around the buckle part, I believe the only way to get that is to replace the entire belt/buckle assembly.
However, if you are talking about the black plastic that goes around the buckle part, I believe the only way to get that is to replace the entire belt/buckle assembly.
01-16-2011, 08:07 PM
#5
MBWorld Fanatic!
A problem with the front two buckles can cause the SRS light to illuminate. All outboard seats have pre-tensioners, and problems with those will also cause an SRS warning.
