07' C280W4 front driver's axel [circlip?]
#1
Super Member
Thread Starter
07' C280W4 front driver's axel [circlip?]
Hello everyone,
Did the front right axle on my 4matic when the control arm gave up the ghost. Using a slide hammer with vise-grips to pull it from the differential worked on the 1st or second slide. Now it's time to do the driver's axle (and control arm), looking at sheet AR33.30-90620P that I found here in another thread and it's shows the Cir-clip on the right side [60n] but doesn't show a Cir-clip for the driver's axle or one on the intermediate shaft [34]. I'll add the pic, does the left side have a Cir-clip? - NP
Did the front right axle on my 4matic when the control arm gave up the ghost. Using a slide hammer with vise-grips to pull it from the differential worked on the 1st or second slide. Now it's time to do the driver's axle (and control arm), looking at sheet AR33.30-90620P that I found here in another thread and it's shows the Cir-clip on the right side [60n] but doesn't show a Cir-clip for the driver's axle or one on the intermediate shaft [34]. I'll add the pic, does the left side have a Cir-clip? - NP
#3
Super Member
Thread Starter
Thanks, yeah it came off, wasn't that bad. Took about 10 slides of vice-grip/slide hammer combo and it came off. Nice new CV and control arm in there now. - NP