I think i found my next mod!
The taillights are BRIGHT!! But they are Loud as well! Can't really notice the sound only after the engine started. On the side note, I found my taillight connector on my passenger side is melted during the install so i had to connect the brown wire on the side. ( seems like many other are just talking about this issue on another thread!!!!!!!
)

How visible are the brake lights and turn signals in direct sunlight? Are they comparable to OEM? I've seen aftermarket LED tail lights on other cars that have pretty poor brake light and turn signal output.
How visible are the brake lights and turn signals in direct sunlight? Are they comparable to OEM? I've seen aftermarket LED tail lights on other cars that have pretty poor brake light and turn signal output.
One thing i wanna bring up is that my driver side brake light is turned on along with the led strip bar( but its very dim and you can't tell unless u get so close. ggms16 do you have that problem? ( i think you can kinda see that from my pic above... just on the driver side )
Last edited by gary_youngster; Oct 5, 2012 at 03:30 AM.
The Best of Mercedes & AMG
As for the new tails, I'll keep watch for now to see if any problems develop and/or how long they last.
Thx! They are bright even in direct sunlight. I say its as bright as oem.
One thing i wanna bring up is that my driver side brake light is turned on along with the led strip bar( but its very dim and you can't tell unless u get so close. ggms16 do you have that problem? ( i think you can kinda see that from my pic above... just on the driver side )

I'm sorry for the late delay. Too busy lately..
I don't have that issue, both looks exactly the same and they are really bright. Make sure you connected the cables tight, if you can sort it out, I would contact the seller. Sorry about that man.
http://www.ebay.com/usr/dotcomracing
i can't wait to see your results. Also, just to help you, you don't need to remove the OEM tail light, just unplug the OEM plug, put the led tail light in the trunk and plug it into led tail lights in order to test them before perfact installation because 1 out 4 bolts are hidden. its not that hard to find but also not that easy to find so.....
https://mbworld.org/forums/c-class-w...ml#post5388081
https://mbworld.org/forums/c-class-w...ml#post5388081
thank you for your diy post.
did you cut the white cable tie that holding all the wire together? i don't think that should be matter but that's only thing i did other than plug and unplug connectors
I did cut the cable tie on one side to relieve a tight wire. However, I velcro wrapped it again after mounting the "ballast" and relieving the wire.
Do you think cutting white cable tie could be the reason why my turn signals are not working? I really want to get this lights working. They are so hot!!!! please help me if you could!!!
https://i.imgur.com/IjQnC.jpg/
https://i.imgur.com/2GxON.jpg
https://i.imgur.com/IjQnC.jpg/
https://i.imgur.com/2GxON.jpg
Thank you for your info!!! can you please show me how the wires are connected? did I do something wrong? or did i unluckly got default item?
They replicate the facelift OEM perfectly without the headache of re-programming.... Love it!
Hope they come back into stock again soon.


