do suction cup dent puller work?
Thread Starter
Member
Joined: Nov 2012
Posts: 237
Likes: 2
C300, ML350
do suction cup dent puller work?
Got my first dent today-- am pissed... Was driving about 60 mph when out of nowhere something hit the passenger A pillar. this caused a small dent (0.5cm) with loss of some paint. This is the first and only dent on my vehicle and have OCD when it comes to dents. My gf was telling me its nothing and you can barely tell -- but I want to fix it. So has anyone tried those cheap suction cup dent pullers? Do those work? Also where can I buy the touch up paint-- should I buy it from MB or would any generic brand work?
MBWorld Fanatic!
Joined: Jun 2012
Posts: 1,229
Likes: 188
From: Toronto
2022 E53 AMG
Don't waste your money.. A dent is not always easy to fix since it stretches the metal.
You can however try carbon ice but use ALL the safety equipment to handle this. I used it once on my old car for a dent that was large than the one you have as it shrinks the metal and causes it to bent back. Kind of the same way when you apply heat to saran wrap.
Take note that it may not work all the time and you need a heater like a blow dryer as you want to cause the metal to flex back fast.
You can however try carbon ice but use ALL the safety equipment to handle this. I used it once on my old car for a dent that was large than the one you have as it shrinks the metal and causes it to bent back. Kind of the same way when you apply heat to saran wrap.
Take note that it may not work all the time and you need a heater like a blow dryer as you want to cause the metal to flex back fast.
MBWorld Fanatic!
Joined: Feb 2004
Posts: 3,986
Likes: 6
From: SEATTLE WASHINGTON USA
'08 C300 Lux Barolo Red Beige Leather P2 MM 18" wheels '84 944
Got my first dent today-- am pissed... Was driving about 60 mph when out of nowhere something hit the passenger A pillar. this caused a small dent (0.5cm) with loss of some paint. This is the first and only dent on my vehicle and have OCD when it comes to dents. My gf was telling me its nothing and you can barely tell -- but I want to fix it. So has anyone tried those cheap suction cup dent pullers? Do those work? Also where can I buy the touch up paint-- should I buy it from MB or would any generic brand work?
For touchup, go to www.paintscratch.com
Thread Starter
Member
Joined: Nov 2012
Posts: 237
Likes: 2
C300, ML350
yeah I thought those suction dent pullers were too good to be true.. appreciate all your suggestions but for the time being I will leave it alone. Next time I bring it in for service I will ask my stealer how much it will cost to fix.
