Looking for SCN coding and Xentry in the northeast region.
#1
Member
Thread Starter
Looking for SCN coding and Xentry in the northeast region.
Hi all. New (used) MB owner. I've been doing quite a bit of research and have come to realize it is not economically feasible to try and buy an SD/Xentry/Sub. Even if I did, I wouldn't really know what I was doing. So getting to the question, are there any members on here that do the live coding or know of any independent shops around that have the hardware/knowledge? I'm located in northeast Pennsylvania but would be willing to take a trip if need be. Thanks in advance for any help.
#3
Member
Thread Starter
Are you aware of any shops in particular down there? I'm looking for someone with the genuine hardware that would be able to go through Xentry and add/switch coding for me. Basically I'm looking to enable M mode and tune the engine to the c350 spec.
#4
Out Of Control!!
Do you know what you are doing---no one uses XDOS to tune-----we code modules that have the capability(hard wired) to be coded----sounds like you need a tuner and dont waste your time with DAS XDOS Xentry bla bla
#5
Member
Thread Starter
I do. "Tune" might not have been the right word to use. I have a '13 C300 which has the same exact engine as the C350, the M276 3.5L. The parts are identical its "de-tuned" from the factory to make the class distinction. As I understand it that needs to be handled through online scn/Xentry.