ESL issue lead to limp mode? No drive
#1
ESL issue lead to limp mode? No drive
Hey guys,
Wondering if anyone can point me towards what I am missing. 2 days ago my ESL went bad, I found the starter relay bypass and tried it twice, just to run the car for few minutes. I drove it once around block and it was fine. Parked it and after removing the plastic cover under steering when which holds the Obdii cable and light bulb and hood latch, I tried to jump the car with relay again and it started but when I put it in drive the car doesn’t move it just revs as if it’s in neutral position, same with reverse it doesn’t move.
I just need to do the fixing of the ESL which I got out and need to send it to reprogram with EIS and new module .
my question is, did something put this into anti theft mode? What would cause this and after new module and EIS will it resolve the issue?
Appreciate your time!
Wondering if anyone can point me towards what I am missing. 2 days ago my ESL went bad, I found the starter relay bypass and tried it twice, just to run the car for few minutes. I drove it once around block and it was fine. Parked it and after removing the plastic cover under steering when which holds the Obdii cable and light bulb and hood latch, I tried to jump the car with relay again and it started but when I put it in drive the car doesn’t move it just revs as if it’s in neutral position, same with reverse it doesn’t move.
I just need to do the fixing of the ESL which I got out and need to send it to reprogram with EIS and new module .
my question is, did something put this into anti theft mode? What would cause this and after new module and EIS will it resolve the issue?
Appreciate your time!