goy0

Hi folks,

I am thinking about retrofit backup camera but I dont have all the part numbers. I am looking for wiring harness P/N. Would be glad if someone could tell me. I am not good with EPC/WIS.

The rest of part numbers are:

Backup camera: A2229050207
Handle: A2227500893
CPF module :A2229005613

Thanks in advance.

chrisdean

The camera should be intergrated into the handle so you shouldn't need to buy it separately. I know that from problems I had with my camera that, as you are facing the boot/trunk that the wiring loom that runs around the right hand boot hinge contains the power to drop down the camera flap and all the video runs down the loom on the left hand hinge.

goy0

Thanks for the info.

Let's see some pictures.

Picture one: General vision of handle + camera.
Picture two: Are these connectors what you said before? I guess wires for these connectors are already attached to the old handle (without camera)
Picture three: Connectors for the harness that I am looking for. From the purple and white goes video wire direct to HU (¿LVDS?) and the other wire is attached to the white one and goes to CPF module and other plugs but dont know exactly where.
Would be glad if someone could share these part numbers.

diamondsilver16

This black connection is the trunk release switch:


The round white/purple connector is camera video, and the square white connector operates the camera flap/door:

goy0

Ok, other picture, here we can see the wires.
The big black one is going to HU, Its video wire LVDS.

The other harness is going from the camera to control unit but I dont know where else, does anybody knows??

BTW, I have found this part number A2055402134, it looks good, but dont know if both wires are included (harness + video cable) or just one.