2013 CLS550-HOW TO RESET AIR SUSPENSION
I ran into an issue where the front right control arm bolt became loose. At first, I thought the control had went bad. So, I was looking to replace it (it is the thin one/centered on hub/chassis.) I removed it. There appears to be a sensor arm that is connected to the rod by a u-bolt. I removed the u-bolt and rotated the arm out of the way. I discovered that the rod was in great shape, however the bolt appeared to be stripped. I purchase a replacement bolt and put it all back together. I go to take the car for a test drive and the air suspension lifts the car fully. I will not sit back down in a normal position. I have tried selecting sport/comfort/lowering options with no luck. The dash reads to the car is too low when it fact it is the opposite. I did not disconnect the battery during the install. And, I jacked up the front end of the car.
Is there a way to reset the air suspension system?
thanks!
Can the airmatic sensor in the front be bad? How to check?
***UPDATE***
So, the car sat in the drive-way for a couple of days. I was looking to get it towed into the nearest dealer for evaluation. I decided to try one last thing. I crawled under the front end and removed the sensor arm from the control arm. I raised it a bit and then the air compression kicked in. I connected it back in place and while doing so the car return to a level mode. I test drove it and everything check up with no warnings. Car has been doing great ever since. Stroke of luck, I believe.
Last edited by tbs456; Oct 1, 2020 at 06:02 PM.