Need a good body shop in Maryland
Thread Starter
Newbie
Joined: Jun 2003
Posts: 19
Likes: 0
From: Maryland
2002 Mercedes C32
Need a good body shop in Maryland
First, the story: My C32 has a small boo-boo (my daughter's word, not mine). It seems that sometimes the vertical rebarb stakes used to hold/position cement parking bump stops in place, are not flush with the top of the bumper stop (my wife's story, not mine!). Anyhow, the lower front facsia, driver's side, got hooked on the rebarb and cracked the facsia. Pretty clean break, so it looks very fixable.
Does anyone have a good contact for a body shop in the Baltimore/Columbia, MD area? Any recommends are much appreciated.
Does anyone have a good contact for a body shop in the Baltimore/Columbia, MD area? Any recommends are much appreciated.
MBWorld Fanatic!
Joined: Jan 2003
Posts: 1,338
Likes: 34
From: Germantown, MD
S550, R350, GL550, ML63 AMG
Wagon Work Collision
Wagon Work Collision in Alexandria, VA specializes in Benz, Audi, BMW, Porsche. I highly recommend them. My little brother got his audi S4 kit installed there. They did a beatiful job. No dust, No orange peel...
I'm getting my rieger rear valance and Carlsson Front lip spoiler installed there later this year. They are the best in the area.
Doug Mullins works in the MB shop
703.706.8151
www.wagonworkcollision.com
I'm getting my rieger rear valance and Carlsson Front lip spoiler installed there later this year. They are the best in the area.
Doug Mullins works in the MB shop
703.706.8151
www.wagonworkcollision.com
MBWorld Fanatic!
Joined: Jan 2003
Posts: 1,338
Likes: 34
From: Germantown, MD
S550, R350, GL550, ML63 AMG
I forgot to mention, they have a lifetime warranty on all of thier work.
http://www.wagonworkcollision.com/pd...meWarranty.pdf
http://www.wagonworkcollision.com/pd...meWarranty.pdf
Senior Member
Joined: Nov 2002
Posts: 371
Likes: 0
From: Boston/Hartford
something similar happened to me as well.
I basically cut through the lower part of the bumper.
I am not sure if yours is similar but because of the tension of the bumper fitment the break usually causes the two pieces to come together and jut out a little over time.
I ended getting a new bumper and it looks much better than a patch up job. But then again I am pretty **** about that stuff.
I basically cut through the lower part of the bumper.
I am not sure if yours is similar but because of the tension of the bumper fitment the break usually causes the two pieces to come together and jut out a little over time.
I ended getting a new bumper and it looks much better than a patch up job. But then again I am pretty **** about that stuff.
