Supercharger pulley sizes to psi
12-14-2009, 12:04 AM
#1
Senior Member
Thread Starter
Join Date: Jul 2007
Location: Long Island, New York
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
2002 Clk430
Supercharger pulley sizes to psi
Hey whats up i usually post over in the w208 section, but knowing a few of you guys are running either the mp90 or mp112 superchargers on your cars i figured you guys might want to know about this site i stumbled upon while researching the hps gen1 kit.
www.boost.xu1.net
just plug in what charger you hav, size of your engine, s/c pulley size, and lower pulley size and itll giv you the psi. dont know HOW accurate it is but its gotta be in the ball park
www.boost.xu1.net
just plug in what charger you hav, size of your engine, s/c pulley size, and lower pulley size and itll giv you the psi. dont know HOW accurate it is but its gotta be in the ball park
12-14-2009, 01:19 PM
#2
MBWorld Fanatic!
Join Date: Feb 2004
Location: Portsmouth, NH
Posts: 1,559
Likes: 0
Received 0 Likes
on
0 Posts
none
Based on discplacemnt and the fact that there shouldn't be any intake restrictions that I can think of it should make the same 4.5ish lbs that mine did. I think once you apply boost the few changes AMG made to the 4.3 shouldn't make a huge difference.
Pulley was milled by HPS and should be the original 2.625 stamped on the piece.
Pulley was milled by HPS and should be the original 2.625 stamped on the piece.
