When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
The placement of the turbo back there would result in massive lag. My brothers twin turbo LS2 setup in his VZ Commodore has the turbos low down near the bell housing. Keeps the under bonnet temps under control too. My modified Nissan S15 ran a fairly decent setup. Built and sleeved motor, Full Race twin scroll / twin gate ex mani from the US and Hypertune intake, T/B fuel rail etc. Autronic management.
That.....is just epic! I've got an S15 and I can tell you, my engine bay and mod-list thus far can only dream to look like yours
2010 Ford G6E Turbo / 2013 C63 Coupe - AMG Performance Pack
Celicasaur, unfortunately my S15 is a memory now as I sold it a few years ago as I bought a 38 ft boat a couple of years earlier and boat stuff was taking over the garage. Plus I wasn't driving it much after buying the boat. The S15 is an awesome platform to start with and I loved the new motor setup with the twin scroll / twin wastegate turbo setup which was kind of cutting edge back in 2009 for this motor. That pic was taken on the day I sold the car and the motor was around 7 years old at the time. If I had somewhere to store it I would have kept it. I was going to E85 it but never quite got there. PM me if you have any questions on the setup.
Celicasaur, unfortunately my S15 is a memory now as I sold it a few years ago as I bought a 38 ft boat a couple of years earlier and boat stuff was taking over the garage. Plus I wasn't driving it much after buying the boat. The S15 is an awesome platform to start with and I loved the new motor setup with the twin scroll / twin wastegate turbo setup which was kind of cutting edge back in 2009 for this motor. That pic was taken on the day I sold the car and the motor was around 7 years old at the time. If I had somewhere to store it I would have kept it. I was going to E85 it but never quite got there. PM me if you have any questions on the setup.
2010 Ford G6E Turbo / 2013 C63 Coupe - AMG Performance Pack
Sounds like it must have been a sheetmetal intake. I split my Hypertune intake twice with the point of failure being around the IACV block welding. Hypertune came to the party and replaced the intake which included a remote IACV setup - no problems thereafter.
Sounds like it must have been a sheetmetal intake. I split my Hypertune intake twice with the point of failure being around the IACV block welding. Hypertune came to the party and replaced the intake which included a remote IACV setup - no problems thereafter.
Then sounds like a sheet metal manifold would have been the next step or get a mold cast if they were planning to produce a kit.from my reading the stock intake manifold is hard to improve upon as far as n/a goes but I wonder if it leaves anything on the table when forced induction is involved.
This is the setup on my brothers LS2......food for thought. Not perfect IMO but works well on the stock LS2.
This looks a lot like a kit that APS from Australia used to make, has an APS feel.
If APS was still around, they'd probably have a kit for the M156 by now.
2010 Ford G6E Turbo / 2013 C63 Coupe - AMG Performance Pack
Yes it is an Aussie APS kit. Only change my brother made after installing the kit and twin 3 inch exhaust was a mafless tune where it made 500rwhp at 5 psi on a dyno dynamics. Has run flawlessly for the last 13 years.
I see on the APS website this kit on an LS1 with 13 psi and mild cam and head work ran mid 9's some years ago.