Facelift C63 P31 Build Thread
#27
Member
Thread Starter
I opted to go with the AC killer chiller drag set up for better cooling. No need to run methanol with this setup. The supercharger IATs will be around 30-40 degrees F. No heatsoak after runs. Ability to advance timing as well.
The following users liked this post:
Ahmed (05-04-2020)
#28
Member
Thread Starter
The E85 kit from Advanced Fuel Dynamics arrived today.
Note: I removed the plastic bags from each individual part for better pictures.
Note: I removed the plastic bags from each individual part for better pictures.
The following users liked this post:
Ahmed (05-04-2020)
#29
Member
Thread Starter
I had a local machine shop work on a 50mm pulley. The end result surpasses my expectations.
Grace Machine in Cudahy. Ask for Danny.
Grace Machine in Cudahy. Ask for Danny.
The following users liked this post:
Ahmed (05-04-2020)
#32
Looks good, can't wait to see the finished product.
Why did you only go stage 2 though?
Why did you only go stage 2 though?
#33
Member
Thread Starter
#34
#35
Member
Thread Starter
#36
MBWorld Fanatic!
#37
yes, I already have a 60mm. But I'm waiting on mr747 to get back to me about a 57mm.
#39
Member
Thread Starter
#43
MBWorld Fanatic!
Join Date: Apr 2002
Location: Bahrain
Posts: 2,570
Received 164 Likes
on
132 Posts
R129 SL55 AMG & W208 CLK55 AMG
Wow..
1. Great work and effort. This is a great project indeed.
2. Thank you for putting the build together for us to see, enjoy, and learn from. Very much appreciated.
3. Subscribed
1. Great work and effort. This is a great project indeed.
2. Thank you for putting the build together for us to see, enjoy, and learn from. Very much appreciated.
3. Subscribed
The following users liked this post:
Ahmed (05-06-2020)
#49
Member
Thread Starter
Due to the delay in obtaining the heat exchanger, Weistec was awesome with their customer service to supply me with a COMPLIMENTARY air oil separator for my build. Can’t wait until it gets here!
Progress photos of the Advanced Fuel Dynamics kit installed. I wanted the setup to look as OEM as possible.
The machined pulley fits nice and snug.
Check out the awesome Weistec oil cap.
Progress photos of the Advanced Fuel Dynamics kit installed. I wanted the setup to look as OEM as possible.
The machined pulley fits nice and snug.
Check out the awesome Weistec oil cap.
The following users liked this post:
Ahmed (05-06-2020)