Good news and bad news.
The following users liked this post:
Cwagon (09-01-2020)
09-01-2020, 12:18 PM
#27
Senior Member
Thread Starter
Sorry about the bad news and also sorry for the delay on the adjusters...
This is all to blame:
New plates
I have some HRC values from the old plates too and was consulting with dkjenis on instagram about making these. The plates above are still yet to be hardened.
Old plates below for reference
As an aside while doing this work I ran into balancing the plates and found out that the camshafts are totally out of balance to begin with. Looking at the intake lobes they are all over the place with the engine’s firing order.
This is all to blame:
New plates
I have some HRC values from the old plates too and was consulting with dkjenis on instagram about making these. The plates above are still yet to be hardened.
Old plates below for reference
As an aside while doing this work I ran into balancing the plates and found out that the camshafts are totally out of balance to begin with. Looking at the intake lobes they are all over the place with the engine’s firing order.
09-01-2020, 05:45 PM
#29
Senior Member
09-01-2020, 07:41 PM
#30
Senior Member
