C63s Dyno mode
#1
Newbie
Thread Starter
C63s Dyno mode
Hi.
Does anyone know how to switch the car to "dyno" mode?
Is this necessary before doing a power measurement as opposed to just switching ESP off?
Thanks
Does anyone know how to switch the car to "dyno" mode?
Is this necessary before doing a power measurement as opposed to just switching ESP off?
Thanks
#2
Switch to Race mode (or Sport+ in non-S models).
Hold down ESP button for several seconds until it shows ESP off.
Switch to Manual mode.
Do the pull in 5th. Typically 4th for most transmissions is closest to 1:1 drive ratio, but for MB 7G-tronic it's 5th.
Not sure if I'm missing something.
Hold down ESP button for several seconds until it shows ESP off.
Switch to Manual mode.
Do the pull in 5th. Typically 4th for most transmissions is closest to 1:1 drive ratio, but for MB 7G-tronic it's 5th.
Not sure if I'm missing something.
#3
Super Member
Follow the same steps as the
old cars, click key on, press ok and call and pull both paddles there is a YouTube video from weistec that I used to do it.
old cars, click key on, press ok and call and pull both paddles there is a YouTube video from weistec that I used to do it.
The following users liked this post:
an.vamv (05-19-2016)
#4
Senior Member
It's under vehicle data. If you go to vehicle settings, then click on dynamic data, then engine data. I'm doing this from the top of my head but I'm at least 75% right. I use it every now and then.