NEW HALO HEADLIGHT ASSEMBLY
#26
MBWorld Fanatic!
Thread Starter
i had to lower then front bumper lil and for the rings (halo) i connect em with the side marker.
then i got me led bulb for that lil bulb so everything matches now .
if u need help from where i got em, let me know
![drive](https://mbworld.org/forums/images/smilies/driving.gif)
#27
Senior Member
This may be a stupid question, but how did you wire them into the side markers? and why are there three sets of black and red wires for two halos per light? Im actually in the middle of install right now, front bumper came off very easy haha
![drive](https://mbworld.org/forums/images/smilies/driving.gif)
#28
MBWorld Fanatic!
Thread Starter
i just split the wire and connected/twisted the wires with with a black tape water proof .. and not a single prob.
#29
Senior Member
By little LED light, you dont mean the city light right? your talking about that tiny tiny one next to the actual projector, I didn't even notice that was there until you mentioned it, the city light is hard to get to on these, were you able to get in there? and did you need much adjusting with yours?
#30
MBWorld Fanatic!
Thread Starter
By little LED light, you dont mean the city light right? your talking about that tiny tiny one next to the actual projector, I didn't even notice that was there until you mentioned it, the city light is hard to get to on these, were you able to get in there? and did you need much adjusting with yours?
#31
Senior Member
I decided not to wire the halos, but the first one is in and HIDs are working, looks really nice, and the city light still works without wiring any of the three black and red lower wires, so that third must be for that little LED i was talking about...??
thanks for your help, moving right along!
thanks for your help, moving right along!
#32
MBWorld Fanatic!
Thread Starter
u could be right. the lil one should come on once u turn the headlight on. i remember i messed up then i had to re do it till i got all working. y aren't u hooking up the halo ring? its the beauty of it specially night. it shouldnt take u more than ten min both sides combined. good luck and you are welcome
#33
Senior Member
I feel like Beamers have the halo's and a lot of aftermarket projectors are now putting in the halo's. I left the wires so I could if I wanted to later. but for now I am happy with the beautiful clear lens and the HID's. It took me about 3 hours total, without wiring halos. it was tough for me to get all the rubber around the lights to line up correctly with the hood and front bumper, its not perfect, but I did the best I could and they look great. I am very happy with the outcome. thanks again!
![drive](https://mbworld.org/forums/images/smilies/driving.gif)
#34
MBWorld Fanatic!
Thread Starter
^^^ welcome but u will change your mind down the road and hook up the halo... its a diff look. yes i had same probs to align the rubber as well but i did the best i could as well.
looking good..
looking good..