My passenger side high beam is not working. When I opened it up the insulation on the wiring were cracking and breaking off. I taped the wires individually so they wouldn't short. I'm not getting any volts to the connector. I have resistance going through the hot and ground wires. I was wondering if there could be a blown fuse, but I can't figure out which fuse goes to the light. Also all other lights on the car are working (except a low beam on the same side which needs to be replaced and shouldn't be related). Any ideas on how to fix this.

any solutions? im starting a new thread for my clk w209

Have you looked in your manual for the different fuse locations? If you have no manual, go to mbusa.com and download one.
There are 3 different fuse locations...engine, trunk and left side of dash...the light fuses are in the side dash locations...charts are in the door.