DIY Replacing MAF question...
Thread Starter
Senior Member
Joined: Mar 2003
Posts: 422
Likes: 13
DIY Replacing MAF question...
I remember a thread a while ago that mentioned the size tool needed to replace the MAF but I can't seem to locate the thread. If anyone could be kind enough to point me in the right direction, I'd appreciate it! Or just tell me what tool to get!!!
MBWorld Fanatic!
Joined: Mar 2002
Posts: 2,781
Likes: 13
From: The Heights, CA
Tesla Model S
The only tool needed is your two hands. Here's what you do:
1. Disconnect the intake hoses
2. Pull off the airbox (held in by about 4 clips)
3. The MAF will be exposed (all the way at the back of the engine
4. The MAF just slips in to the rubber seal - pull it out and disconnect the wiring
5. Repeat in reverse to put everything back together.
1. Disconnect the intake hoses
2. Pull off the airbox (held in by about 4 clips)
3. The MAF will be exposed (all the way at the back of the engine
4. The MAF just slips in to the rubber seal - pull it out and disconnect the wiring
5. Repeat in reverse to put everything back together.
