CLK500 coupe 2005 with ESP problem..solved
Thread Starter
Newbie
Joined: Dec 2010
Posts: 2
Likes: 0
2006 CLK500
CLK500 coupe 2005 with ESP problem..solved
Okay...I read some of the treads....and they all have different issues.
My car was going into ESP warning and into limp mode. for 2 weeks I had to stop the car and restart.
Mechanics here in CT....no clue...
I have the Engine light on and off all summer car always ran fine. when off.
mechanics you have a trim problem it could anything....BLA..BLA.
Your ESP: I clean the connections...ad you may need a new Module...$800 + $400 labor.
so I took it to Imported cars of Darien in Norwalk.
They hired a guy to come over and diagnostic with a MB scanner (that is the only thing that can scan MB cars)
The screen show the following codes:
P0103 B2/5 Mass Air flow sensor
P1999
P0221 fault in the monitor in the electronic accelerator
ESP
C1510 fult in communication N63/1 DTR control Module
C1024 Can't communicate with engine system is faulty
The guy...looked at the faults traced all back to a bad Air mass sensor.
He pop the hood looks at it and said to me...replace it with a BOSCH that one is NON-BOSCH. JUNK!
PROBLEM SOLVED!
My car was going into ESP warning and into limp mode. for 2 weeks I had to stop the car and restart.
Mechanics here in CT....no clue...
I have the Engine light on and off all summer car always ran fine. when off.
mechanics you have a trim problem it could anything....BLA..BLA.
Your ESP: I clean the connections...ad you may need a new Module...$800 + $400 labor.
so I took it to Imported cars of Darien in Norwalk.
They hired a guy to come over and diagnostic with a MB scanner (that is the only thing that can scan MB cars)
The screen show the following codes:
P0103 B2/5 Mass Air flow sensor
P1999
P0221 fault in the monitor in the electronic accelerator
ESP
C1510 fult in communication N63/1 DTR control Module
C1024 Can't communicate with engine system is faulty
The guy...looked at the faults traced all back to a bad Air mass sensor.
He pop the hood looks at it and said to me...replace it with a BOSCH that one is NON-BOSCH. JUNK!
PROBLEM SOLVED!
