Trunk partition mounting
#1
Member
Thread Starter
Trunk partition mounting
![](https://cimg7.ibsrv.net/gimg/www.mbworld.org-vbulletin/1500x2000/20191027_160208_1854424d5613bad114627b064c30297d8a2d4ee3.jpg)
So today I replaced the struts for the trunk partition bit noticed that something seems to be missing in the photo where I have the zip ties. Does anyone know what is suoposed to be there...dowel mayb
![](https://cimg9.ibsrv.net/gimg/www.mbworld.org-vbulletin/2000x1504/20191027_160219_c7f96c4aa89c0fc44160e8b6860cf4cd8fc84e7e.jpg)
This is looking down with the clamshell filling open
Last edited by redciv1; 10-27-2019 at 07:55 PM.
#2
Member
If I’m not mistaken there should be a plastic fastener that locks this hinge in place. Plastic fastener has a clip on its end that secures it in place. Once the clip brakes that fastener simply falling out from this hinge. I guess it’s a zip tie workaround there on the picture.
Currently I have 2 CLK’s - both of them have at leat one broken fastener
Currently I have 2 CLK’s - both of them have at leat one broken fastener
![Smilie](https://mbworld.org/forums/images/smilies/smile.gif)