Error code P1CE700, CEL, CE crankcase wide open throttle
#1
Member
Thread Starter
Error code P1CE700, CEL, CE crankcase wide open throttle
Hey guys,
anyone get this error message before and was able to fix it or locate a possible cause?
anyone get this error message before and was able to fix it or locate a possible cause?
#2
Super Member
I, myself, haven't seen one on this forum, as far as I know. But going to follow this thread just for the information. Hopefully, someone can chime in with details.
#3
Member
Thread Starter
I usually get the CEL when I floor it and the engine sucks air. This is the only extra piece of information that I have.
The following users liked this post:
doug5790 (02-05-2024)
#4
Super Member
Looks like you just need to find out where the air leak is. Inspect the visual parts for anything and maybe a compression test is required? And as the diagram states, check if all the clamps are tightened. A loose clamp will leak air, too. Especially the ones that go on turbo charge pipes.
That's all I can say. Rest is beyond my knowledge.
That's all I can say. Rest is beyond my knowledge.
The following users liked this post:
Mssidah (05-19-2021)
#5
Newbie
Join Date: May 2023
Posts: 4
Received 0 Likes
on
0 Posts
'19 GLS550 Renntech Cl600, S63, Bentley Arnage, ‘21 Ram 2500 Longhorn
I have the same code with CEL. Only under hard acceleration. Did not do this before I installed Renntech tune. No other symptoms. I believe the control unit is simply seeing an increase in air flow that it doesn't understand. I am going to spray a little carb cleaner around the intake hoses, connections, etc. If there is the slightest leak, the RPM will jump slightly at the introduction of cleaner(fuel) to the intake system.