should I put this on my cls?
#1
Super Member
Thread Starter
should I put this on my cls?
Looking to do a control arm replacement and wanted to save some money so I ordered a cheap chiense bundle off amazon. I examined it and there were holes on the thin rubber area that connects to the chassis. I assumed I got a bad batch and ordered another set, with the same issue. At this point I just figured this isn't a part to cheap out on so I went with a german oe brand and have the exact same issue. I am now wondering if these are just imperfections to expect. BTW I didn't order the german parts off amazon I am sure they are authentic. I attached some pictures of what the german control arms I got look like.
Last edited by Dnasty; 07-12-2017 at 01:11 AM.
#3
Super Member
Thread Starter
I didn't put this part pictured on my car btw and the amount of labor that goes in to this job (if it's diy) i'd recommend going top of the line lemforder.. you don't want to do this again atleast not for another 100k.
The following users liked this post:
LexBrett2 (07-31-2017)
#4
Super Member
The holes are just part of the rubber casting that is very thin, the bit that isnt actually rubber bush and is nothing to worry about