stefkrunevski

So after changing brake pads discs and engine mounts, when the car was lowered down from the lift the right side was bendy and more up than the left one. The technicians tried to add pressure in the left one and while doing it the airstruck blowed and we went on to repair it and now it is good but the car still can not go into Confort suspension, and its very low. On the OBD the fault is C156e00 Airmatic level calibration not succesfull. the fault is stored and current

ANY HELP WOULD BE IN VALUE. Thank you in advance

Roscoefour

Have you looked at the level sensor? It’s a little arm with a plastic ball joint at each end, they have a habit of coming undone, which results in the suspension going down, however it’s a cheap and easy fix.

Cesar Koubek

Hi i have the same problem on my mb w212 what was your issue?