Easy first question. Windshield washer nozzle.
Thread Starter
Super Member
Joined: Dec 2015
Posts: 604
Likes: 238
From: Suburban Maryland
2023 E 450 Sedan. 2018 GLC 300. 2013 E 350 Coupe (retired)
Easy first question. Windshield washer nozzle.
Is there any way to adjust the spray pattern? Not sure how to say this without getting comments, but I would like to adjust the spray higher up the window. Thanks.
Thread Starter
Super Member
Joined: Dec 2015
Posts: 604
Likes: 238
From: Suburban Maryland
2023 E 450 Sedan. 2018 GLC 300. 2013 E 350 Coupe (retired)
Figured it out (I think)
Ok, I guess it is a standard nozzle. Found a high end adjustment tool on Amazon, no cheap metal pin for me! Thanks.
Thread Starter
Super Member
Joined: Dec 2015
Posts: 604
Likes: 238
From: Suburban Maryland
2023 E 450 Sedan. 2018 GLC 300. 2013 E 350 Coupe (retired)
Ok, back with same question. It does not look or feel adjustable. There is hole in center and two slots, one above and one below on each nozzle. No movement with gentle attempts. I used to have an Audi with nozzles with very limited adjustment, may have to live with it I suppose. VIN WDDKJ8JB9DF199935
Junior Member
Joined: May 2016
Posts: 60
Likes: 4
From: Santa Cruz, Ca.
2023 EQB250+; 2004 CLK320 Cabriolet
It would not appear the spray angle is adjustable and I find it to be a little low on the windscreen as well. However, my bigger problem was that one of the nozzle units was broken on the 2010 E350 coupe i just purchased. The mechanics at Big O tires were able to diagnose the issue. There is a small ball bearing in the bottom of each unit that had fallen out in my middle unit causing most of the fluid to be dumped and leaving no pressure for the others. They were able to bypass this unit so the the other two now function until i can get a replacement part from MB.
Great work from Big O tires!
Great work from Big O tires!
Thread Starter
Super Member
Joined: Dec 2015
Posts: 604
Likes: 238
From: Suburban Maryland
2023 E 450 Sedan. 2018 GLC 300. 2013 E 350 Coupe (retired)
There is a tool that may fit our nozzle, not sure if this is right for a 207 however 001 589 02 16 00
Last edited by smiles201; Dec 13, 2025 at 02:28 PM.
