H-ManZX

Hi guys,


does anyone have directions or a manual how the soft top can be adjusted? In particular I'm interested in adjusting the main anchor sidewards (see picture).

Thanks!

Plutoe

Yea, go to Startek WIS--it's all there!!

H-ManZX

Thanks for the tip! But it seems that service is only available to U.S. residents and I'm located in Germany. Here, the corresponding service is not offered to private individuals at all.

Plutoe

Post your VIN and I will spend some time looking for the documents!!

Plutoe

First, I must say that I have never removed or installed a soft top therefore I am at a small disadvantage---never the less there at about thirty documents pertaining to the soft top, but I think that what you are looking for is included within the attached very detailed removal\install instructions for your VIN's soft top---if not then you must gain access to WIS.

H-ManZX

Thank you so much!

Plutoe

The dimensional data is included at the bottom of the page under "Check values and Gaps"----see R and S


The location of the gaps on MB 207 vehicles is now attached to my previous post. Go down the page to your 207.4 picture for the R and S locations.

H-ManZX

Again, thanks! I will report back once I was successful (or not)