When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Tony MYMB, I looked at your google install photos and was curious as to your LED dynamic turn signal install with the "welcome home" light that activates after the signal completes. Did you run a wire the welcome home LED down into the puddle light in the lower door? ie. The picture with the single dual pin connector coming from the bottom of the door & speaker grill?
Or is it possible to just tap into one of the pins at the connection box below? Curious as to what your trial & error was and if that was a good ACC source for that light to only come on when you lock & unlock the car.. any help is appreciated!
yes, I found the puddle light connections from the door module in the last photo I simply removed some of the plastic insulation and soldered the link wire you only need the positive for when the door is open.
I then pulled the green stimming wire into the mirror tapped the red wire to the strimming wire and soldered up the other end
09-23-2020, 10:39 AM
