Replaced the steering wheel tilt dogbone, limited tilt range
07-21-2019, 03:37 PM
#1
Senior Member
Thread Starter
Replaced the steering wheel tilt dogbone, limited tilt range
Bought the car with non-functional steering tilt. After replacing the dogbone it didn't work right away, the motor would only turn one way, after disconnecting the battery it finally started working in both directions (up/down) but the range of tilt is about 2 inches. With the seat on the lowest position and the steering wheel on the highest I can finally see the entire cluster but just barely. Anybody know if there's a reset or a calibration for range of tilt?
Last edited by Fantomas; 07-21-2019 at 03:40 PM.
07-22-2019, 10:41 AM
#2
Out Of Control!!
Join Date: Jul 2003
Location: North Scottsdale, AZ
Posts: 15,903
Received 4,441 Likes
on
3,153 Posts
'71 Pinto
All aligned properly, see attachments.
07-22-2019, 07:41 PM
#3
Senior Member
Thread Starter
07-23-2019, 12:40 PM
#4
Out Of Control!!
Join Date: Jul 2003
Location: North Scottsdale, AZ
Posts: 15,903
Received 4,441 Likes
on
3,153 Posts
'71 Pinto
Yes, I was suggesting to revisit to see if anything is binding and confirm all is operating properly.
