2006 CDI Cluster LED burnt out?

Subscribe
Jan 18, 2020 | 07:48 AM
  #1  
Hi all,

I’ve been searching for a solution for this but figured I might get a better response by asking.

Attached is a picture of a problem I’m having. The 20, 40, 120, 140 mph lights have gone out. Everything else works as it should.

Any ideas on a fix?

thank you!

Reply 0
Jan 18, 2020 | 09:26 AM
  #2  
No bulbs, you can disassemble cluster to visually inspect (ribbon cables, etc.) however, more than likely you will need to replace cluster. Need VIN to provide compatible part #s to shop used, then swap board to retain mileage, etc.





Reply 0
Jan 19, 2020 | 12:28 AM
  #3  
Quote: No bulbs, you can disassemble cluster to visually inspect (ribbon cables, etc.) however, more than likely you will need to replace cluster. Need VIN to provide compatible part #s to shop used, then swap board to retain mileage, etc.

hello Konigstiger,

do you have access to the actual schematic for the cluster? I have an intermittent cruise control segmented display problem, I am believing its a cold solder connection to a chip. It seems to be cabin temperature dependent. Shopping for a used cluster may have the same problem, it seems this is a common issue.
Reply 0
Jan 21, 2020 | 02:21 PM
  #4  
Unfortunately not, this is as far as MB goes not much help as far as you're concerned.


Reply 0
Subscribe
Currently Active Users (1)