drive cycle 2004 e 500
Thread Starter
Newbie
Joined: Jan 2014
Posts: 13
Likes: 0
E500
drive cycle 2004 e 500
I just installed new cats (front & rear) on passenger side (direct fit -Magniflow).
Can't pass safety check (snog). I understand there is a "drive cycle" i must complete.
I have searched and searched for info on what I need to do to reset the computer to accept a test for
ob11 reader.
OOOOPS wrong section need to move to 211
Can't pass safety check (snog). I understand there is a "drive cycle" i must complete.
I have searched and searched for info on what I need to do to reset the computer to accept a test for
ob11 reader.
OOOOPS wrong section need to move to 211
Last edited by snowshoejeep; Mar 16, 2018 at 04:42 PM.
MBWorld Fanatic!
Joined: Jan 2009
Posts: 9,225
Likes: 1,798
From: V E G A S
1922 Ford Model T / no OBD
No matter what car model or brand - all OBD -equipped cars have to run the drive cycle to become "smog ready".
Some states allow 1 or 2 points "not ready" so if you have hard time to fix the issue - check what is actual requirement.
My $10 Bluetooth scanner with Torque Pro lists all the points and their status.
http://epa.ohio.gov/Portals/27/echec...riveCycles.pdf
Some states allow 1 or 2 points "not ready" so if you have hard time to fix the issue - check what is actual requirement.
My $10 Bluetooth scanner with Torque Pro lists all the points and their status.
http://epa.ohio.gov/Portals/27/echec...riveCycles.pdf
