Windshield replaced, auto wipers issue
Thread Starter
MBWorld Fanatic!
Joined: Jun 2008
Posts: 2,073
Likes: 85
From: San Francisco, CA
2017 E300
Windshield replaced, auto wipers issue
Statefarm was making it difficult to get the windshield replaced at a dealership so I went to one of their recommended shops. After work was completed, the wipers are not functioning correctly. At start up, they will wipe once and then not work again. That is, putting my hand on the sensor did not activate it.
I did some searches online and found a method to reset them, that is put to 0 position on stalk, start engine, switch to 3rd position, then back to 0, then on 1 (auto low). Now, when I start the car, it is still wiping once, but the wipers will function correctly when touch the sensor. How do I get it to stop wiping at startup?
I did some searches online and found a method to reset them, that is put to 0 position on stalk, start engine, switch to 3rd position, then back to 0, then on 1 (auto low). Now, when I start the car, it is still wiping once, but the wipers will function correctly when touch the sensor. How do I get it to stop wiping at startup?
