Easy entrance and exit
Thread Starter
Junior Member
Joined: Apr 2011
Posts: 62
Likes: 10
glk
Easy entrance and exit
On EQE, I have two drivers. No 1 sets seat nearly back and I activated easy in and out and seat is back as I shut off and open door. No 2 is way up and in memory 2. Easy in out also activated, but it won't move back when turning off. If I get in after No 2. As driver no 1. Seat is up, memory buttons won't work. Etc. A pain until I can select no 1 on screen.
I see some people have seat tied to remote, no such option in my profiles. Dealer is clueless as usual
So question is. How to set easy in and out seat as t position for driver no2 without messing up desired seat in memory 2?
I see some people have seat tied to remote, no such option in my profiles. Dealer is clueless as usual
So question is. How to set easy in and out seat as t position for driver no2 without messing up desired seat in memory 2?
Senior Member
Joined: Mar 2023
Posts: 368
Likes: 136
EQE350 SUV 4MATIC
The Home > Settings > Vehicle > Easy entry and exit setting is global rather than associated with a specific profile, i.e., when set it should operate for both profiles. That is how it works in my EQE SUV. When the vehicle is turned off by either driver the seat moves to the common entry/exit position.
Thread Starter
Junior Member
Joined: Apr 2011
Posts: 62
Likes: 10
glk
My no 1 way back driver moves all the way back. The No 2 way up close seat does move but not as far as No 1. Might delete no 2 and start over to see if it works.
Also no settings to link key fob to profile as ive seen on Suvs. Maybe my 20k service can update software.
Also no settings to link key fob to profile as ive seen on Suvs. Maybe my 20k service can update software.
Senior Member
Joined: Mar 2024
Posts: 349
Likes: 138
From: California
2024 EQE Sedan
The Home > Settings > Vehicle > Easy entry and exit setting is global rather than associated with a specific profile, i.e., when set it should operate for both profiles. That is how it works in my EQE SUV. When the vehicle is turned off by either driver the seat moves to the common entry/exit position.
Thread Starter
Junior Member
Joined: Apr 2011
Posts: 62
Likes: 10
glk
What did you set, where you want seat when exit and where save, in a memory? If memory, where save actual desired seat position ? I must have saved something right for Number 1 driver, but seat is OK for number 2, but exit moves only 1/2 inch instead of Way back like no 1. I put seat position for number 1 in memory 1 and number 2 in memory 2 and never purposely saved any of them someplace for exit position.
