Mark this thread as Unsold
Finally W211 CF Quad Diffuser!!!!!!!
03-31-2010 | 02:17 PM
#264
Junior Member
Joined: Aug 2008
Posts: 55
Likes: 0
From: avon, ohio
'05 E55, '06 300c SRT8
diffuser fitment issue
I've installed my diffuser but the passenger side edges are not shaped properly on my particular piece. I've tried contacting JBSPEED but was only told to remove bumper and try again. He hasn't offered any more assistance. It is not a placement issue, the curvature is off on this side. I've tried refitting and refitting, it will not match up properly. You can see this in the first pic below:
Passenger side:
Drivers side:
Rear view:
The drivers side is perfect. I've used screws to try and snug it up but the CF-like material is not flexible. I guess I'm left to using bondo or another material to fill the gap. It does not look good as is, the gap is about 1/2". Any other suggestions?
Todd
Passenger side:
Drivers side:
Rear view:
The drivers side is perfect. I've used screws to try and snug it up but the CF-like material is not flexible. I guess I'm left to using bondo or another material to fill the gap. It does not look good as is, the gap is about 1/2". Any other suggestions?
Todd
04-26-2010 | 02:30 PM
#269
Thread Starter
SPONSOR
iTrader: (1)
Joined: Oct 2008
Posts: 27,956
Likes: 50
From: home
Lexus NX200T F-Sport AWD
Thanks for the online orders!! www.jbspeed.com
05-03-2010 | 10:52 PM
#272
Senior Member
Joined: Feb 2010
Posts: 389
Likes: 1
From: Texas
2005 Silver E55
Todd what ever happen on this. I am looking for a Diffuser but if this is the quality ,I will look else where.
let me know. JBspeed whats up. your front lip was great .
let me know. JBspeed whats up. your front lip was great .
I've installed my diffuser but the passenger side edges are not shaped properly on my particular piece. I've tried contacting JBSPEED but was only told to remove bumper and try again. He hasn't offered any more assistance. It is not a placement issue, the curvature is off on this side. I've tried refitting and refitting, it will not match up properly. You can see this in the first pic below:
Passenger side:
Drivers side:
Rear view:
The drivers side is perfect. I've used screws to try and snug it up but the CF-like material is not flexible. I guess I'm left to using bondo or another material to fill the gap. It does not look good as is, the gap is about 1/2". Any other suggestions?
Todd
Passenger side:
Drivers side:
Rear view:
The drivers side is perfect. I've used screws to try and snug it up but the CF-like material is not flexible. I guess I'm left to using bondo or another material to fill the gap. It does not look good as is, the gap is about 1/2". Any other suggestions?
Todd
05-03-2010 | 11:31 PM
#273
Senior Member
Joined: Feb 2007
Posts: 376
Likes: 0
From: Southern California
C300. FJ Cruiser, 370Z
