Coding Help Needed! GLC63 FL tailights installed on pre-FL
#1
Coding Help Needed! GLC63 FL tailights installed on pre-FL
Need some help from those that do coding. Installed genuine MB 2020 taillights on a 2019 using CKS adapters. All works fine, but when first using the right/left taillight after starting you get the "check taillight message" and it blinks inside the car at twice the speed which is just annoying. After clearing the message it doesn't show up again until you restart. Also, even though it clicks at twice the speed in the car, the taillights blink at normal speed (thank god). Anyone have any recommendations from the board on who could fix this outside of BenzNinja? Didn't want to have to go a full package route if someone could fix with a module or OBD2 plug in somehow.
Thanks in advance.
Thanks in advance.
#2
SPONSOR
iTrader: (4)
Joined: Dec 2019
Posts: 2,700
Received 864 Likes
on
671 Posts
From: WWW.BENZNINJA.COM
WWW.BENZNINJA.COM
Need some help from those that do coding. Installed genuine MB 2020 taillights on a 2019 using CKS adapters. All works fine, but when first using the right/left taillight after starting you get the "check taillight message" and it blinks inside the car at twice the speed which is just annoying. After clearing the message it doesn't show up again until you restart. Also, even though it clicks at twice the speed in the car, the taillights blink at normal speed (thank god). Anyone have any recommendations from the board on who could fix this outside of BenzNinja? Didn't want to have to go a full package route if someone could fix with a module or OBD2 plug in somehow.
Thanks in advance.
Thanks in advance.