GLE 450 "Engine Screen"
#1
Member
Thread Starter
GLE 450 "Engine Screen"
Along with HP, Torque etc. there is a graph for "Charge -air Press". Called the dealer maint department who did not know what it was for. Best guess is turbo boost pressure or when a diesel comes along for it. Mine reads 0 all the time no matter what load I put on the motor. I figured someone here would know. Had the car 5 months now and I am still trying to figure some things out. lol
Thanks
Thanks
#6
Member
Join Date: May 2015
Location: Florida
Posts: 109
Received 15 Likes
on
12 Posts
2020 GLE 450 + 2019 Audi eTron
Along with HP, Torque etc. there is a graph for "Charge -air Press". Called the dealer maint department who did not know what it was for. Best guess is turbo boost pressure or when a diesel comes along for it. Mine reads 0 all the time no matter what load I put on the motor. I figured someone here would know. Had the car 5 months now and I am still trying to figure some things out. lol
Thanks
Thanks
#7
Member
Thread Starter
Thanks
Trending Topics
#8
MBWorld Fanatic!
Join Date: May 2018
Location: Boise
Posts: 3,367
Received 1,030 Likes
on
698 Posts
2024 GMC Canyon Denali..... 2018 Audi SQ5
It’s the same on our Audi and GLE 450...there is no Boost to register unless you are driving with some decent acceleration or pulling a hill or trailer. HP & Torque readings are there from the start (even at idle) unless the vehicle is Coasting with the Engine off. If yours doesn’t register at hard acceleration then something is malfunctioning.
The following users liked this post:
jcapotos (05-03-2020)
#9
Member
It must be different for the diesels as mine always shows a reading unless in park or I have my foot completely off the accelerator.
Driving at 30mph I see readings between 50/70 kPa, this was on a very slight incline.
The most I’ve been able to get it to is about 270 kPa.
Driving at 30mph I see readings between 50/70 kPa, this was on a very slight incline.
The most I’ve been able to get it to is about 270 kPa.