ml320, mercedes benz 2002. Running issues, keeps stalling when put into gear.
#1
Newbie
Thread Starter
Join Date: Mar 2013
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
mercedes benz ml320 2002
ml320, mercedes benz 2002. Running issues, keeps stalling when put into gear.
After a workshop manual for my ml320 2002 to diagnose problem. Anyone can help, everything go to in google has been no help.
When put into gear always stalling, or if get to go it will stall when l stop at traffic lights or intersection. Any help.
When put into gear always stalling, or if get to go it will stall when l stop at traffic lights or intersection. Any help.
#4
MBWorld Fanatic!
#5
Newbie
Thread Starter
Join Date: Mar 2013
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
mercedes benz ml320 2002
Thankyou for your advice, cant find vacuum leak but put a vacuum guage on it an it shows it has vacuum leak but when l disconnect the air mass sensor the guage reads as if their was no vacuum leak an car runs an drives well,
Any advice what you think
Any advice what you think
#6
MBWorld Fanatic!
That is very strange because the workings of the MAF Sensor has no bearing on intake manifold vacuum. It only registers the volume of incoming air going to the throttle actuator.
From what you are saying, it seems that you need a new Bosch MAF Sensor, but have the codes read first. It should show codes of P0100-1004.
From what you are saying, it seems that you need a new Bosch MAF Sensor, but have the codes read first. It should show codes of P0100-1004.