GPS Antenna
Junior Member
Joined: Aug 2013
Posts: 25
Likes: 1
'05 ML350 SE
- Unscrew the antenna cover using a special wrench (should come with the installation kit)...or take a look at the cover to see if you can figure out an alternative.
- Unscrew the threaded sleeve.
- Disconnect phone and GPS antenna.
- Install is reverse.
Additional info:
- The plastic sill cover on the ceiling liner by the lift gate has 2 screws on each ends. Remove the screws and pull the plastic sill down (and off).
- Carefully open the liner and you'll see the phone and GPS antenna cables, etc...
- Unscrew the threaded sleeve.
- Disconnect phone and GPS antenna.
- Install is reverse.
Additional info:
- The plastic sill cover on the ceiling liner by the lift gate has 2 screws on each ends. Remove the screws and pull the plastic sill down (and off).
- Carefully open the liner and you'll see the phone and GPS antenna cables, etc...
Senior Member
Joined: Mar 2002
Posts: 282
Likes: 5
From: Brisbane, Australia
2002 ML320, 2003 A160
The rectangular-based GPS antenna is held on by a nut under the roof. You access it by removing the plastic cover at the top of the tailgate opening, which just pops off. Avoid breakage by using a plastic wedge or large flathead screwdriver.
