Replacing brake pads - pin is stuck!
Thread Starter
Newbie
Joined: Mar 2016
Posts: 2
Likes: 0
'05 ML 500 SE (W163 left hand steering)
Replacing brake pads - pin is stuck!
Replacing my brake pads and I have one pin which will not budge at all. I have been using a 1/8 punch and lightly using a hammer to punch them out - all of them came out fine, but the top on one side. I actually broke my punch trying to get this one out and had to run to autozone to get another.
So, any ideas as to how to get this thing out? As it is sitting jacked up in the garage tonight I put some liquid wrench on there, but won't find out if that did anything till tomorrow. I assume it is the larger end with the compression ring (the inside end towards the engine) that is stuck.
Other things I thought of were applying some heat, but I am worried about how close that is to things. Another was drilling it as I am replacing with new ones anyways, but again a little worried with that as I want the new one to fit securely.
Surely someone else has run into this problem... what did you do to get it out?
So, any ideas as to how to get this thing out? As it is sitting jacked up in the garage tonight I put some liquid wrench on there, but won't find out if that did anything till tomorrow. I assume it is the larger end with the compression ring (the inside end towards the engine) that is stuck.
Other things I thought of were applying some heat, but I am worried about how close that is to things. Another was drilling it as I am replacing with new ones anyways, but again a little worried with that as I want the new one to fit securely.
Surely someone else has run into this problem... what did you do to get it out?
Thread Starter
Newbie
Joined: Mar 2016
Posts: 2
Likes: 0
'05 ML 500 SE (W163 left hand steering)
