Molding and bumper covers.
#1
Almost a Member!
Thread Starter
Join Date: Jan 2002
Location: Bronx
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
1998 ML 320
![Question](https://mbworld.org/forums/images/icons/icon5.gif)
Greetings all.
I got into a little mishap over the weekend. My bumper cover was snagged a van's bumper, causing the bumper to slide out fo the clips that hold it in. Because of the presure of forcing it out, thee paint was chipped on the back left of the bumper cover where it buckled. It is not that bad...a paint chip about 3 inches in diameter is now there and the bumper needs to be tucked back in.
Can anyone advise on how to slide it back in?
Also does anyone know where I can get all the molding and bumber covers in Black instead of the grey that is currently on the 1998 ML 320.
Thank you
I got into a little mishap over the weekend. My bumper cover was snagged a van's bumper, causing the bumper to slide out fo the clips that hold it in. Because of the presure of forcing it out, thee paint was chipped on the back left of the bumper cover where it buckled. It is not that bad...a paint chip about 3 inches in diameter is now there and the bumper needs to be tucked back in.
Can anyone advise on how to slide it back in?
Also does anyone know where I can get all the molding and bumber covers in Black instead of the grey that is currently on the 1998 ML 320.
Thank you
#2
Senior Member
Join Date: Nov 2001
Location: SoCAL,:-))
Posts: 310
Likes: 0
Received 1 Like
on
1 Post
2000 ML320/'03 C320WZ
Try to take the whole bumper off and slide it back in. If you don't know how to take the bumper .Here it is:
there are three square opening on the back bumper, to open it use the the screw driver to pry it off it will bw attach with two plastic string sort of... and you will see the screw holding the bumper take that screws off, pull the bumper off then push it back in, ensure both side is line up to the track. Hope this will help.
there are three square opening on the back bumper, to open it use the the screw driver to pry it off it will bw attach with two plastic string sort of... and you will see the screw holding the bumper take that screws off, pull the bumper off then push it back in, ensure both side is line up to the track. Hope this will help.