Transmission stuck in 2nd gear. Need help
#1
Transmission stuck in 2nd gear. Need help
Have a 99 Ml320
transmission would occationally lock lock up in 3rd gear and I could reset it by turning the car on and off.
now it is stuck in 2nd gear. Even when I turn the car on and off again.
i decided to replace the
transmission plate
all the solenoids
transmission connector plug.
i also checked the tcm and plug for oil and both are dry.
i tried erasing the codes with a snap on but codes are still present and it does not unlock the transmission
transmission would occationally lock lock up in 3rd gear and I could reset it by turning the car on and off.
now it is stuck in 2nd gear. Even when I turn the car on and off again.
i decided to replace the
transmission plate
all the solenoids
transmission connector plug.
i also checked the tcm and plug for oil and both are dry.
i tried erasing the codes with a snap on but codes are still present and it does not unlock the transmission
#2
MBWorld Fanatic!
What scanner are you using?
It sounds like you do not have a correct scanner to clear the codes.
It sounds like you do not have a correct scanner to clear the codes.
#3
Snap on Solus ultra.
Snap on solus ultraTCM codes
Before I cleared the codes these were the codes
013 speed sensor n3 y3/6l1
109 speed sensor n3 y3/6l1
132 ecm can communication or ect implausible
135 can communication disturbed: engine management
after erasing I got these codes and now it’s stuck on these codes no matter how many times I erase the codes
005 pwm valve y3/6y6 torque converter lock up
101 pwm valve y3/6y6 torque converter lock up
These are engine codes
P0715