2002 ML500 Limp Home Mode
#1
Junior Member
Thread Starter
Join Date: Oct 2019
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
2006 Mercedes-Benz E320 CDI
2002 ML500 Limp Home Mode
I have a 2002 ML500 and it goes into limp home mode after I turn it on and drive it for 8 minutes. When it goes into limp home mode a bunch of lights light up on the dash. It drives perfectly fine before it goes into limp home mode. If I pull aside, put it in park, and restart it, then I can continue just fine for another 8 minutes. I checked the 13 pin connector, but it’s dry. I have code P0720, P0600, and P0730. What might this be? The conductor plate has also already been replaced.
#2
MBWorld Fanatic!
Look at highlighted codes on pages 12 & 13. It indicates that there is a problem in Trans. Control Module and codes must be read in that module.
Reading the codes in the Trans. Module will determine what speed sensor is at fault.
Reading the codes in the Trans. Module will determine what speed sensor is at fault.
#4
MBWorld Fanatic!
Since you posted codes in the ECM, I presumed you had a scanner. A code reader will not do.