2008 ml320
#1
Junior Member
Thread Starter
Join Date: May 2018
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
ml320
2008 ml320
Changed the motor due to a cap coming off a rod and going through the block. The only code I am getting with the new motor is TCM not communicating. The vehicle starts, runs then stops within a few seconds. Will the TCM fault cause this? The other thing I have been reading is oil gets in the plug and stops it conducting for the transmission, were is the plug for this, and is there any fuses for the TCM to check?