Hello, first question in this part of the board.
My girlfriend has an ML350 2006 and it has been a moneypit.
However, straight to the point, my question is:
I have changed the balanceshaft a couple of years ago, everything went fine and engine ran good.
It still runs good, but it have developed an intermittent error in the last year.
Both exhaustcams is giving me a code and says they are retarded.
And, NOT the intake cams on any of the banks, just the exhaust.
This to me rules out that the camchain is stretched or the gear on the balanceshaft has worn out again.
As it would give me codes on both camshafts on the right cylinderbank.
What are your first thoughts?
Rgds
Patrick
My girlfriend has an ML350 2006 and it has been a moneypit.
However, straight to the point, my question is:
I have changed the balanceshaft a couple of years ago, everything went fine and engine ran good.
It still runs good, but it have developed an intermittent error in the last year.
Both exhaustcams is giving me a code and says they are retarded.
And, NOT the intake cams on any of the banks, just the exhaust.
This to me rules out that the camchain is stretched or the gear on the balanceshaft has worn out again.
As it would give me codes on both camshafts on the right cylinderbank.
What are your first thoughts?
Rgds
Patrick
After some research this morning i came up with a possible fault.
Magnets.
Does it sound like a plausible fault in this case?
Magnets.
Does it sound like a plausible fault in this case?
BlackML550
MBWorld Fanatic!
close
Yesterday
- Join DateJun 2014
- LocationMelbourne, Australia
- Posts:1,086
-
iTrader Positive Feedback0
-
iTrader Feedback Score(0)
- Vehicle(s) I drive2010 ML550 VIN WDC1641722A564750, 2010 B180
-
Likes:711
-
Liked:442 Times in 353 Posts
This thread seems similar in some ways and may guide you.
https://mbworld.org/forums/mercedes-...n-erratic.html
https://mbworld.org/forums/mercedes-...n-erratic.html
Thanks, will read it after i get off from work today =)
