M-Class (W166) Produced 2012-2015

Rear Brake Pads

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old Jul 15, 2019 | 01:19 PM
  #1  
Etienne Lau's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2017
Posts: 487
Likes: 114
From: DFW, TX
Ml350 bluetec
Rear Brake Pads

I am looking to DIY replace the rear pads on my 2014 ML 350 Bluetec. When I search on the internet, there are 2 sets of brake pads, one set is for those vehicles with the AMG Exterior Sport Package. The VIN #: 4JGDA2EBXEA407633. My concern is pictures of rear rotors for the non AMG vehicle are solid vs vented rear rotors. And my vehicle has vented rear rotors. So any help would be appreciated in figuring out which pads to purchase. Attached is a picture of the rear rotor/brakes

Thank you,


Reply
Old Jul 16, 2019 | 12:32 AM
  #2  
Rainers's Avatar
Senior Member
 
Joined: Feb 2002
Posts: 303
Likes: 46
From: Minneapolis/ St Paul
Are you original owner, are the front vented.

My 2014 ML350 all wheel drive gas has vented in the front and solid in the back. Bought off the lot brand new and dealer replaced the back rotors at 3k because they were defective and prematurely grooved.

check you fronts, perhaps a previous owner swapped out the rotors and put them on wrong end of the vehicle.

Reply
Old Jul 16, 2019 | 09:26 AM
  #3  
vinceC's Avatar
Super Member
20 Year Member
Photogenic
 
Joined: Nov 2001
Posts: 789
Likes: 55
From: Henrico, Virginia
2014 ML350 4Matic
That photo doesn't look like a vented rotor. It looks like a solid rotor that was balanced during manufacturing. The groove is where material was machined out to balance the rotor. Maybe send a better photo?

Last edited by vinceC; Jul 16, 2019 at 09:27 AM. Reason: Correct spelling
Reply
Old Jul 16, 2019 | 05:02 PM
  #4  
Etienne Lau's Avatar
Thread Starter
Senior Member
 
Joined: Jul 2017
Posts: 487
Likes: 114
From: DFW, TX
Ml350 bluetec
Originally Posted by vinceC
That photo doesn't look like a vented rotor. It looks like a solid rotor that was balanced during manufacturing. The groove is where material was machined out to balance the rotor. Maybe send a better photo?
Thank you. Turns out you are correct, I took a closer look and indeed it is not a vented rear disc.

Thank you all.
Reply

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 


You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -4. The time now is 04:19 PM.