w203 command/tv wiring harness, what is this black connector?
#1
w203 command/tv wiring harness, what is this black connector?
Hi everybody I have just installed the full comand wiring harness. However, I do not know what is this black 10 pin connector with 2 blue wires. Where do I connect it to? please help!
#3
MBWorld Fanatic!
Join Date: Jul 2005
Location: Sydney, Australia
Posts: 3,220
Likes: 0
Received 10 Likes
on
6 Posts
W203 slightly modified
Originally Posted by perdikoula888
please help!
It is a common point to COMAND, UHI, VCS, stacker and BOSE.
IT is a common joining block for those devices and represents the copper side of the optical signal.
#4
MBWorld Fanatic!
Join Date: May 2003
Location: Houston, TX
Posts: 4,002
Likes: 0
Received 96 Likes
on
52 Posts
2015 E250D
That is the wakeup line for all the fiber optic connected devices. Just like benzmodz said. If your fiber connected items are ever dead, check the wakeup line, fiber loop, and makesure each device is getting power.
#5
Thank you both for the help, will check it in the morning when I go to the garage. Is the block that has to be connected close to the foot kick panel? are there any more wire connected to this blck or is it a dedicated block solely for this 2 wire 10 pin plug?
....Or it stays unconnected just with the loop clip on it?
still learning slowly...
thank you for your patience
....Or it stays unconnected just with the loop clip on it?
still learning slowly...
thank you for your patience
Last edited by perdikoula888; 03-05-2006 at 06:50 PM.
#6
MBWorld Fanatic!
Join Date: Jul 2005
Location: Sydney, Australia
Posts: 3,220
Likes: 0
Received 10 Likes
on
6 Posts
W203 slightly modified
Originally Posted by perdikoula888
Thank you both for the help, will check it in the morning when I go to the garage. Is the block that has to be connected close to the foot kick panel? are there any more wire connected to this blck or is it a dedicated block solely for this 2 wire 10 pin plug?
....Or it stays unconnected just with the loop clip on it?
still learning slowly...
thank you for your patience
....Or it stays unconnected just with the loop clip on it?
still learning slowly...
thank you for your patience