Max77

Hi
I have purchased this diangostic interface for my laptop

http://cgi.ebay.com/Mercedes-Benz-Sc...QQcmdZViewItem

but when connect OBD cable to my W203 the laptop doesn't connect.
Can you help me?

tom0329

How is it working did you get the software with it?

Max77

I use Carsoft V7.4 MB, when I try to connect shown this messages:

Comunication under costrution....

Module is not build in, or does not respond

tom0329

I've been reading up on this site.
http://www.obd2allinone.com/sc/toplevel.asp?cat=0

David in OZ

I have the same Carsoft 7.4 Interface............ works well with my 1997 SLK 230K

Are you using a 38pin diagnostic connector or the 16pin OBD11 connector?

Not familiar with your MB model....? year.....this interface is not compatible with CAN-BUS

Cheers

David

Max77

I have a 08/2001 C class and use OBD2 16 PIN connector.
Are you sure that it is not compatible with Can Bus?

David in OZ

Most sellers state 'compatible with original interface'......which I read to mean the 38pin interface before OBD11

An OBD11 cable was supplied with my unit, but I understand it only works with pre CAN-BUS MB's

Link to one seller who states 'Not compatible with CAN-BUS'

http://ucables.com/ref/MB-CARSOFT

Cheers

David

Max77

Where can I purchase an interface CAN BUS compatible?