Getting through the firewall
#1
Senior Member
Thread Starter
Join Date: Feb 2007
Location: Sammamish
Posts: 282
Likes: 0
Received 0 Likes
on
0 Posts
'02 CLK55
Getting through the firewall
Ok bit the bullet and bought the M20 Extreme Laserjammer and going to install it. I need to find a way through the firewall. I did a quick look at it and did not see a easy way through. Any suggestions on which side and if there is a pass through.
Might as well ask too, I am going to mount the LED and on/off switch by the light switch, how does the face come off to drill the holes.
Might as well ask too, I am going to mount the LED and on/off switch by the light switch, how does the face come off to drill the holes.
#2
Senior Member
Thread Starter
Join Date: Feb 2007
Location: Sammamish
Posts: 282
Likes: 0
Received 0 Likes
on
0 Posts
'02 CLK55
Well I got one of these installed in my Mariner found a perfect hole that just had a plug in it. Popped it out and bingo I was in, perfect install. Any way to get through the firewall? The wire has a RJ11 phone jack plug on the end so it is larger than just a wire.