Knock noise.....I guess?
#1
Member
Thread Starter
Join Date: Jul 2007
Location: Wilmington, NC
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
2006 MB C230 Iridium Silver, 2007 Hummer H3 Slate Blue
Knock noise.....I guess?
I am hearing a somewhat of a knock noise when I am at idle coming from the back end of my car. It sorta sounds like someone is tapping their index finger on a desk but lightly. I can't seem to duplicate it for the dealer.
#2
Member
Thread Starter
Join Date: Jul 2007
Location: Wilmington, NC
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
2006 MB C230 Iridium Silver, 2007 Hummer H3 Slate Blue
Could it be coming from the fuel pump? Now don't forget to sit at your desk and tap your finger on it from a light to moderate tap(without using your fingernail).......thats what it sounds like. It took me a while to figure out a comparison...hahaha! Damn, maybe someone or something is in my trunk!
#3
Member
Join Date: Dec 2006
Location: Newport Beach
Posts: 129
Likes: 0
Received 1 Like
on
1 Post
2005 C55 AMG Silver Bullet
MY C55 RECENTLY WENT INTO SERVICE FOR SOME SPLINES IN THE AXEL ?
I HAVE NO IDEA MY AXEL WAS THE ISSUE...
I HEARD ISSUES FROM BRAKE PADS MOVING AROUND? TO TRANNY ISSUES..
THOUGH MY SERVICE TECH TOLD ME HE HAD TO REPLACE THE SPLINES IN THE AXEL ?
ANYONE EVER HEAR OF THIS BEFORE?
I HAVE NO IDEA MY AXEL WAS THE ISSUE...
I HEARD ISSUES FROM BRAKE PADS MOVING AROUND? TO TRANNY ISSUES..
THOUGH MY SERVICE TECH TOLD ME HE HAD TO REPLACE THE SPLINES IN THE AXEL ?
ANYONE EVER HEAR OF THIS BEFORE?
#4
Junior Member
Join Date: Sep 2007
Location: brisbane,Australia
Posts: 16
Received 0 Likes
on
0 Posts
mercs.lots of em!
A tapping noise at idle ,in drive?, Could be a loose exhaust pipe banging on the floor or a transmission mount rubber has failed.
had to replace the splines in the axle????? or replace the axle shafts...? !? The Shaft on the left is "Splined" ,so tell me ,how is your mechanic going to change those splines..Hmmm?
had to replace the splines in the axle????? or replace the axle shafts...? !? The Shaft on the left is "Splined" ,so tell me ,how is your mechanic going to change those splines..Hmmm?