This thread is also under GLE dash-cam question but I guess I placed it in the wrong section... can anyone with WIS access assist please?

So I have purchased the MB front and rear dash-cam, along with the harness, memory card etc.
However, there are no instructions on how to install the harness. I am an electronics engineer so I could cut-off the connectors and find suitable sources for the wiring (eventually) but I would much rather install this as it is supposed to be.
I have been advised by the supplier that the details are in the Mercedes WIS database, but obviously don’t have access to it. Has anyone on the forum installed this harness before? Or know how and where it’s connected. The harness setup part number is A213 820 93 03.
I have a new GLE late 2019 (167)..

 

Please post your VIN. I'm not sure the 167 is available in most WIS versions. Try searching ebay for WIS and see if your model is listed. Being an electronics engineer the WIS software will be well worth it for you.

 

Hi chassis, many thanks for the reply... VIN Number is WDC1671192A016538

 

LastVIN didn't find your VIN and neither did WIS. I tried to search generically with no VIN but no joy.

 

Hmm interesting... here is a shot from my Mercedes Me.

 

Different database for different countries maybe..? I am 6,000 miles away from you!

 

Many thanks for your assistance Chassis, I took your advice and I am currently downloading the 2020 version of WIS/ASRA and EPC service repair workshop manuals. I’ll post the results once it’s completed.. huge files!

 

good luck with downloading something that does not exist

careful with ebay scammers, there is no 2020 WIS/ASRA and EPC offline