300SDTURBOS

All:

What is a good source/part number for a tool to tighten the injectors on my 300SD diesels?

Looks like I need something akin to a "2-tooth" socket to tighten the injector. I have a very slight seep at base of a couple of injectors.

Thanks for the help.

DRG

orcberg

I believe the tool you're looking for is Snap-On part# S6104B. It's like $30. 1/2" drive, 12-point 27mm socket. It's used for MB and VW diesels.

300SDTURBOS

ORCBERG:

Thanks. The 12-point looks this looks OK for the injector body however, there is a two-slot/two-tooth threaded sleeve in the head that the injector screws into. I assume there is a special tool for that too. The 12-pt is only for the injector/body.

Any other suggestions? Thanks


DRG