Dyno in Chicago area? N-NW suburbs
#1
Senior Member
Thread Starter
Dyno in Chicago area? N-NW suburbs
I am looking for a place to do a baseline Dyno before adding tunes to the car, and I am north of Chicago. Any recommendations? AMS said that they only do it for cars they tune.
#2
Out Of Control!!
Join Date: Jun 2004
Posts: 11,401
Received 1,883 Likes
on
1,320 Posts
2014 E63S; AMS 100 octane ecu tune; edok tcu tune; BB intakes; dyno tuned
Garage Kwai in Arlington heights
Also a four wheel dyno in naperville on Ogden avenue they do a lot of Wrx dynos
http://www.flp*********/
Also a four wheel dyno in naperville on Ogden avenue they do a lot of Wrx dynos
http://www.flp*********/
#3
Senior Member
Thread Starter
Thanks. Finish Line is a bit far from me for a simple Dyno. I did not know Kwai was doing Dyno and still around. I used to go to them when I was tuning my Accord back in 2000, and know that they moved but their quality went down.
Since I have not had to Dyno my car except for training at UTI (my brother did Hot Rod Training), I was asks for opinions. Right now I know of the following:
Fall Line in Nortbrook ($250 for 3 pulls or so on a Mustang Dyno)
Speed Inc in Schaumburg ($125 for 2 pulls on Dynojet)
P and L Motorsports in Lisle ($80 for 3 pulls on Dynojet)
GT Haus in Bensenville is having grand opening this week AFAIK.
Funny how the further from my house I go (Winnetka), the cheaper the Dyno. I am looking to do a pre and post pull with ROW air boxes to be sure that I don't lose power with the mod, and so I may have to do more than a baseline pull.
Since I have not had to Dyno my car except for training at UTI (my brother did Hot Rod Training), I was asks for opinions. Right now I know of the following:
Fall Line in Nortbrook ($250 for 3 pulls or so on a Mustang Dyno)
Speed Inc in Schaumburg ($125 for 2 pulls on Dynojet)
P and L Motorsports in Lisle ($80 for 3 pulls on Dynojet)
GT Haus in Bensenville is having grand opening this week AFAIK.
Funny how the further from my house I go (Winnetka), the cheaper the Dyno. I am looking to do a pre and post pull with ROW air boxes to be sure that I don't lose power with the mod, and so I may have to do more than a baseline pull.
#4
SPONSOR
Join Date: Jul 2007
Location: Houston/ Austin /Toronto / UAE / Minneapolis / Orlando /Cincinnati
Posts: 5,459
Received 148 Likes
on
108 Posts
Eurocharged Performance ML63 and TT lambo
$250 for 3 pulls is a joke
Speed inc is good, and there is always chicago performance and tuning in melrose park
you should be fine with the row boxes. I would only dyno if you were getting tuned and not worry about the ROW
Speed inc is good, and there is always chicago performance and tuning in melrose park
you should be fine with the row boxes. I would only dyno if you were getting tuned and not worry about the ROW