Sensor numbner of MAF in APEXI
05-23-2008, 05:22 AM
#1
Newbie
Thread Starter
Join Date: May 2008
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
W202 C230 Kompressor
Sensor numbner of MAF in APEXI
I'm going to install a Apexi AFC in my W202 C230K
Even if there is no the wiring diagram for my car, I still can trace the wiring for the AFC for installation.
However, I do not know the exact sensor type and what is the number of "IN" and "OUT" for the setting in the AFC. So, I cannot go futher more for the tuning of the Air/Fuel Ratio of the engine.
Does anybody can help
Thanks
Even if there is no the wiring diagram for my car, I still can trace the wiring for the AFC for installation.
However, I do not know the exact sensor type and what is the number of "IN" and "OUT" for the setting in the AFC. So, I cannot go futher more for the tuning of the Air/Fuel Ratio of the engine.
Does anybody can help
Thanks
05-23-2008, 10:12 PM
#2
MBWorld Fanatic!
Why
have you modified the engine that you need to change the fuel demand under load?
It's a nice toy on some ricer that gets more boost or a bigger turbo,but if you have not done any major mods the ecu will adapt to a richer mixture under full throttle as part of its own program.
I see serious issues in your future
ohlord
It's a nice toy on some ricer that gets more boost or a bigger turbo,but if you have not done any major mods the ecu will adapt to a richer mixture under full throttle as part of its own program.
I see serious issues in your future
ohlord
